Hyundai Veloster N Forum banner
21 - 27 of 27 Posts

·
Registered
2020 vn pp
Joined
·
9 Posts
Yes and no small hole 4 gauge won't fit. Have to use my smaller jl amp and maybe 8 gauge wire .my 16 vt had so much more room to run wires .
 

·
Registered
2020 vn pp
Joined
·
9 Posts
So ended pushing the hood release grommet out and ran the 4 gauge to the trunk . I have bass but my high low stays on it is voltage sensing. Maybe defective.
 

·
Registered
Joined
·
3 Posts
Hello all,
I just did this on my 21 DCT.

Audio control lci2 pro
Skar svk2 3500.1
2 skar evl 15 dual 2ohm
Pretty serious bass with this setup. Trying to run 1/0 power wire was a real treat...

If anyone need some tips ,ask away.
6139
6140
 

·
Super Moderator
Joined
·
1,833 Posts
Holy $hit!!! That IS insane! lol.... I bet it PUMPS!!!!!!

Best regards,

-Mike
 

·
Registered
Joined
·
3 Posts
Lol, it does! To anyone tapping the rear sub lines, you only need 2. In the lci2 just do a neg and a pos to the left input of the l.o c. All 4 is to hot.
Thanks man.
 

·
Registered
Joined
·
16 Posts
Firewall plug under the dash. You can see it from the engine compartment with the battery and ECU removed.
Just use a fish wire (coat hanger, etc.) through the grommet and into the engine bay. I've run several wires through here with no additional disassembly.. Accessible from the footwell...to the left where the hood release cable goes through the firewall
 
21 - 27 of 27 Posts
Top