Hyundai Veloster N Forum banner
1 - 15 of 15 Posts

·
Registered
Joined
·
21 Posts
Discussion Starter · #7 ·
Very nice! How do you like the H&R springs?
As far as appearance goes I love them. Riding in the car is a little stiff but not too bad. In N mode it is super stable and takes curves better than stock. Once I put the splitter on the front it really made me start slowing down to pull into places at an angle so I didn’t scrape the bottom of the splitter but sometimes it still does.
 

·
Registered
Joined
·
122 Posts
A recommendation sliplo its a sudo skid plate . www.sliplo.com they go on easily and protect against damage made of polyurethane . i have it on my 2020 VN PP i have a multi angle entrance and departure from my apartment . i needed it so i could save the bottom of my bumper.
 

·
Registered
Joined
·
21 Posts
Discussion Starter · #15 ·
Nice mods! Question: did you only use the supplied holes on the APR splitter?
Thank you. I did drill additional holes to match the engine cover. And mounted the splitter to the bumper and the engine cover using bolts and washes I bought from Lowe’s. So its all basically one piece, which sucks to take on and off, but that’s not something I’ve had to do often so it’s not that big of a deal. Also once it’s on the car as one piece I used really long bolts to go thru the splitter and cover and bolted into the four hole that go into the radiator bracket.
 
1 - 15 of 15 Posts
Top