Hyundai Veloster N Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #3 ·

·
Registered
Joined
·
184 Posts
I’m trying to get off the H logo though-which has pins. I would assume I have to disassemble the trunk to get the pins out or do I just pull hard?
The pins are there just for alignment when it is being installed at the factory. Do not just pull really hard, you will damage the paint.

My preferred method is a heat gun and floss, but if you're not familiar with using a heat gun on paint use the lowest setting and make sure to keep it moving. If you let it sit too long on one spot, you'll cook the clearcoat.
 

·
Administrator
Joined
·
2,092 Posts
I use Red's method and a hair dryer on low. I also keep the hair dryer moving a bit too. I heat it up first then use the fishing line then clean it up with WD-40. Hope this helps?

Best regards,

-Mike
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top