Hyundai Veloster N Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
78 Posts
I've lived over there and in Sierra Vista a lot in the last 25 years, but sadly I'm stuck in Texas right now. We're looking to move back out there next summer though. I know @tatted_up_jazz (IG) is out there with a red 2019 Veloster Turbo. She has the stuff from Gorilla Splitters and hexagons all over the back of it. :) And then there are a couple groups on FB for second gen Velosters, but I can't think of anyone else in Tucson off the top of my head right now.
 

·
Registered
Joined
·
99 Posts
Discussion Starter · #3 ·
I've lived over there and in Sierra Vista a lot in the last 25 years, but sadly I'm stuck in Texas right now. We're looking to move back out there next summer though. I know @tatted_up_jazz (IG) is out there with a red 2019 Veloster Turbo. She has the stuff from Gorilla Splitters and hexagons all over the back of it. :) And then there are a couple groups on FB for second gen Velosters, but I can't think of anyone else in Tucson off the top of my head right now.
Yeah, I know tatted_up_jazz on FB and IG. There's a tiny little scene here and quite a few more in the PHX sprawl.
 

·
Registered
Joined
·
99 Posts
Discussion Starter · #5 ·
They're Konig Ampliforms in 18x8.5et45 with Michelin Pilot Sport PS4's in 245/35. The factory wheels and tires were on the car for only 300 miles before I replaced them. 19's are just too big and too heavy for a car as small as the Veloster in my opinion.
 

·
Registered
Joined
·
53 Posts
Thanks. I'm in the same boat (Chalk White PP, located up near Phoenix, car is still relatively new) and looking to swap to 18s. I'm limiting my search to wheels with an offset >=50; leaning toward the BBS SRs, but they're on the high end of what I'd like to spend:

2782
 

·
Registered
Joined
·
99 Posts
Discussion Starter · #7 ·
I wouldn't worry too much about offset as long as you keep it within 10mm of factory. Mine are 45 and there's a barely perceptible difference in torque steer and honestly I think that could be tuned out with alignment.

Also, if you're on FB, there's a KDM group we've started up for AZ. Log into Facebook | Facebook
 
1 - 7 of 7 Posts
Top