Just dropped my car off for some R&D with AFE Power to develop an intake for the Veloster N. Will keep you all updated on how it goes.
131.1 KB Views: 1,033
That's only in a couple weeks. My N's in storage til April anyway but I am sure I won't save 20% in April so I am jumping on this now. So is this thing a 4" flange all the way to the turbo pipe? Thanks in advance.Not yet, this is a pre-order status and won't be released until Jan.:wink::grin:
Let us know! I think this will be my next mod. I am only holding off purchasing because I am working on getting my other car compliant with the law and my wife will actually divorce me if I appear to be working on both cars simultaneously.I hope it fits the Forge turbo tube because I just purchased the AFE Intake. If it does taper then I will come up with something to make it fit the Forge tube. One way or another I am going to make it work. Anything else is unacceptable! I'll let everyone know the quality once it arrives.
14 degrees here tonight. Yey!!! Yes, that was sarcasm. lol.... You must know it's in storage. I'm not doing any installs until March or April. My a$$ is getting old and needs a break. Problem is, I'll probably have 25 things to install. I'll be wiped out a month into the new season. Ha, ha... I have to say I see the axle back exhaust in my dreams. It's calling to me bad.... lol... :devil:Mike so, it's warm in the upper 50 and lower 60's here.:grin: You can always install it and make noises with your mouth!!!:grin::wink:
As far as I can tell it 4" all the way to the turbo inlet. Even if it's not, you can purchase the silicone coupling inlet pipe with the same turbo inlet size to match in intake pipe. I'll find the site again and post it here.
HPS Silicone Air Intake Hose Tube Post MAF Reinforced High Temp Turbo Inlet